本文已被:浏览 694次 下载 382次 |
![本文二维码信息](/download_upload_file.aspx?file_name=/uploadfile/two_dimensional_code_img/zgnydxxb/2019/7/20190714.png) 码上扫一扫! |
日光温室夜间后墙不同高度放热量差异的理论分析 |
张传坤1, 魏珉2, 刘福胜3, 徐平丽4, 李岩2
|
|
(1.山东省农业科学院 蔬菜花卉研究所, 济南 250100;2.山东农业大学 园艺科学与工程学院, 山东 泰安 271018;3.山东农业大学 水利土木工程学院, 山东 泰安 271018;4.山东省农业科学院 生物技术研究中心, 济南 250100) |
|
摘要: |
针对日光温室夜间后墙不同高度放热量差别较大的现象,运用物理学矢量原理、气体分子动理论,对外界低温通过覆盖面在后墙形成的放热机理进行推导,结合放热机理和后墙不同高度温度差别对后墙不同高度放热量差别的影响进行研究。结果表明:1)外界低温驱动力水平分量大小随后墙高度降低不断增大,外界低温驱动力水平分量密度随后墙高度降低不断减小,后墙放热驱动是外界低温驱动力水平分量大小和密度乘积的函数,随后墙高度降低不断增大。2)后墙放热后温度不断下降,后墙放热量自上而下逐渐增多,下侧放热量是上侧放热量的2~3倍。3)推导出的后墙放热机理能够解释后墙不同高度放热量差异,后墙不同高度放热量差异主要是由于外界低温通过覆盖面在后墙产生的放热驱动不同造成的;后墙放热是外界低温驱动下的被动放热。4)后墙温度较高时,后墙放热量受后墙温度和后墙放热驱动共同作用,此时后墙中部放热量也会较多;后墙温度较低时,后墙放热量主要受后墙放热驱动作用。 |
关键词: 日光温室 后墙 放热机理 驱动力 放热驱动 被动放热 |
DOI:10.11841/j.issn.1007-4333.2019.07.14 |
投稿时间:2018-07-31 |
基金项目:国家大宗蔬菜产业技术体系建设专项(CARS-23-04);"十二五"国家科技支撑计划课题(2014BAD05B03);山东省农业重大应用技术创新课题(鲁财农指(2015)16) |
|
Theoretical analysis on the heat-releasing volume differences of back walls at different heights in solar greenhouse at night |
ZHANG Chuankun1, WEI Min2, LIU Fusheng3, XU Pingli4, LI Yan2
|
(1.Vegetable Research Institute, Shandong Academy of Agricultural Sciences, Jinan 250100, China;2.Horticulture and Engineering College, Shandong Agricultural University, Taian 271018, China;3.College of Water Conservancy and Civil Engineering, Shandong Agricultural University, Taian 271018, China;4.Bio-Tech Research Center, Shandong Academy of Agricultural Sciences, Jinan 250100, China) |
Abstract: |
Aiming at the phenomenon that the heat-releasing volume of back wall at different heights in solar greenhouse are quite different,this study first deduce the heat-releasing mechanism of the back wall formed by the outer low temperature through greenhouse cover by using physics vector principle and the gas molecular movement theory as foundation and then carry out the research on heat-releasing difference of different heights of the back wall in combination with the heat-releasing mechanism and the differences of the temperature of back walls at different heights.The results show that the horizontal component of the external low-temperature driving force increases and the density of the horizontal component of the external low-temperature driving force in the back wall decreases with the decreasing of the back wall height.The heat-releasing drive formed by the outer low-temperature is the function of the product of driving force with the driving force density,and it increases with the height of the back wall decreasing.The temperature of the back wall decreases continuously after releasing heat.The heat-releasing volume from the back wall increases gradually from the top to the bottom,and the heat-releasing volume from the bottom side are 2-3 times higher than that from the top side.The deduced exothermic mechanism can explain the heat-releasing difference of different height back walls,and the heat release of the back wall is a passive heat-releasing process driven by the external low temperature.The difference of heat-releasing volume is mainly due to heat-releasing drive caused by external low temperature.The heat-releasing volume is affected by the heat-releasing drive and the temperature of the back wall when the temperature of the back wall is high and the heat-releasing volume in the middle of the back is also high;The heat-releasing volume of the back wall is mainly driven by the heat-releasing drive of the back wall when the temperature of the back wall is low. |
Key words: solar greenhouse back wall heat-releasing mechanism driving force heat-releasing drive passive heat release |